Wireless Setup Wizard - D-Link DAP-1610 User Manual

Section 3 - Configuration
The setup wizard is designed to guide you through a step-by-step process to configure your new DAP-1610
AC1200 Mesh Wi-Fi Range Extender to extend your wireless network and connect to the Internet via a wireless setup process. To set
your DAP-1610 using an ethernet cable, please refer to "Access Point Mode Settings" on page 23.
To access the setup utility for the DAP-1610 AC1200 Mesh Wi-Fi Range Extender-
on your PC, first connect to the DAP-1610 wirelessly using the Wi-Fi name (SSID)
and password located on the back of your DAP-1610. Then open a web browser
and enter http://dlinkap.local./ in your browser's URL field. You may also enter
the IP address* of the DAP-1610.
* The default IP address is 192.168.0.50. Once your DAP-1610 connects to the host network,
it will be assigned a new IP address based on your network's DHCP settings. You will need
to log in to your router to see what IP address is assigned to your DAP-1610. For multiple
DAP-1610s, go to http://dlinkapxxxx.local. as shown on the included Quick Installation
Card, with "xxxx" being the last four digits of the DAP-1610's MAC address.
If this is your first time logging in to the extender and no connection has been
established, the setup wizard will automatically appear. If the setup process was
not previously completed, then log in to the interface by leaving the password
field blank.
D-Link DAP-1610 User Manual

Wireless Setup Wizard

DAP-1610
http://dlinkapwxyz.local./
Username: Admin
Device Password: password
P/N: CAP1610LCA....B1
S/N: S81P1YMXXXXXX
MAC ID: XXXXXXXXXXXX
FCC ID :KA2AP1610B1
H/W Ver.: B1 F/W Ver.: XXXX
I C:4216A-AP1610B1
Wi-Fi Name(SSID): dlink-xxxx
M/N:DAP-1610B1
Wi-Fi Password: XXXXXXXX
CAN ICES-3 (B)/NMB-3(B)
Input: 100-240Vac, 50/60 Hz, 0.3A Max
Made In China
16