Auto Cycle - Gestetner CP6143L Operating Instructions Manual

C2678608_Platinum-EN.book Page 35 Sunday, February 12, 2006 10:53 PM

Auto Cycle

Using the default settings, you can
process masters and make prints in a
single operation. This is called "Auto
Cycle".
A
Make sure the {Auto Cycle} key is
lit.
Note
❒ If it is not lit, press the {Auto Cy-
cle} key.
B
Place your originals.
Reference
See p.28 "Placing Originals".
C
Make sure the {Master Making}
mode select key is lit.
Note
❒ If it is not lit, press the {Master
Making} mode select key.
D
Make the necessary settings.
E
Enter the required number of prints
using the number keys.
F
Press the {Start} key.
ANT125S
Note
❒ When the print job finishes, press
the {Clear Modes} key. Previously
entered job settings are cleared.
Auto Cycle
2
ANT122S
ANT128S
35