Placing Originals; Placing Originals On The Exposure Glass; Placing Originals In The Auto Document Feeder - Gestetner CP6143L Operating Instructions Manual

C2678608_Platinum-EN.book Page 28 Sunday, February 12, 2006 10:53 PM
Basics

Placing Originals

When using the exposure glass, place
the originals face down.
When using the ADF, place the origi-
nals face up.
2
Placing Originals on the
Exposure Glass
A
Lift the exposure glass cover.
Note
❒ Be sure to lift the exposure glass
cover more than 30°.
B
Place the original face down on
the exposure glass. The original
should be aligned with the left
scale.
1.
Left scale
28
C
Lower the exposure glass cover.
D
Adjust print settings as necessary,
and then press the {Start} key.
Placing Originals in the Auto
Document Feeder
A
Adjust the guide to the original
size.
B
Insert the aligned originals face up
into the ADF.
ANT064S
Note
❒ To avoid originals misfeeding,
fan the originals before placing
them in the ADF.
Limitation
❒ Approximately 30 originals (80
2
g/m , 20 lb) can be inserted at a
time in the ADF. The first (top)
original will be fed first.
Note
❒ To avoid jamming, fan the orig-
inals before placing them in the
ADF.
ACY070S ❒ The guides must fit snugly against
both sides of the stack.
AJK153S