Basic Operations; Turning On The Cd Receiver; Setting Auto Standby (Asb); Selecting The Input Source - Onkyo CR-245BT Instruction Manual

E39_CS-355_En_120614.book 17 ページ ２０１２年６月１４日 木曜日 午後１時４８分

Basic Operations

This section describes the procedure for using the
remote controller, unless otherwise specified.

Turning On the CD receiver

Press the On/Standby [8] button.
The CD receiver comes on, and the display lights up.
Press the On/Standby [8] button again to set the CD
receiver to Standby.
You can also use the [8 ON/STANDBY] button on the
CD receiver.
During the use of your iPod/iPhone/iPad connected to
the CD receiver with a USB cable, if the connection
mode of the CD receiver is set to iPod (see page 22),
"Charging" appears on the display of the CD receiver
and your iPod/iPhone/iPad will be charged even with the
CD receiver on standby.
Tip:
• For details on power management settings, see "Set-
ting Auto Standby (ASb)".

Setting Auto Standby (ASb)

With Auto Standby, you can set the CD receiver so that
it will be automatically turned off and enter the standby
mode if there is no operation for 20 minutes with no
audio input.
The default setting is "Off".
Make settings for this function while playback is
stopped.
1 Press and hold down the remote
controller's [SLEEP] button (about 3
seconds).
If this setting is "On", "AutoStby On" will appear
on the CD receiver's display.
Note:
• To switch between "On" and "Off", repeat this
procedure.
• If an iPod/iPhone/iPad is connected, ASb will not
operate because the connected unit is being charged.
• If playback is paused, the power will remain on even
after 20 minutes have elapsed; the Auto Standby
function will not operate.
• With Bluetooth Standby "On", the CD receiver will
enter the Bluetooth Standby mode if the Auto Standby
function is enabled (see page 23).

Selecting the Input Source

You can select CD, iPod (USB), FM, AM, Bluetooth, or
LINE, which can be an external component.
To select the input source, use the remote controller's
Input Selector buttons. On the CD receiver, press the
[INPUT] button repeatedly.
The input sources are selected in the following order.
CD iPod (USB)
LINE

Adjusting the Volume

To adjust the volume, use the VOLUME [–]/[+]
buttons.
You can also use the CD receiver's VOLUME [–]/[+]
buttons.

Muting the CD receiver

You can temporarily mute the output of the CD receiver.
Press the [MUTING] button.
The CD receiver is muted.
"Muting" appears on the display for a few seconds. The
MUTING indicator flashes continuously while the CD
receiver is muted.
Note:
• To unmute, press the [MUTING] button again or
adjust the volume.
• Muting is automatically cancelled when the CD
receiver is set to standby.

Using Headphones

You can connect a pair of stereo headphones (ø3.5 mm,
1/8-inch phone plug) to the receiver's headphones [=]
jack for private listening.
Note:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the
headphones [=] jack, the speakers are turned off.
FM AM
Bluetooth
17