Basic Operations; Turning On The Cd Receiver; Adjusting The Volume; Selecting The Input Source - Onkyo CR-555 Instruction Manual

Basic Operations

This manual describes the procedure for using the
remote controller, unless otherwise specified.

Turning On the CD receiver

To turn on the CD receiver, press the On/Standby [ ]
button on the remote controller.
Press the On/Standby [ ] button again to set the CD
receiver to Standby.
You can also use the [ ON/STANDBY] button on the
CD receiver.
Tip:
• For details on power management settings, see "ASb
(Auto Standby)" (see page 30), "SleepCharge" (see
page 30).

Adjusting the Volume

To adjust the volume, use the VOLUME [ / ] button.
You can also use the [VOLUME] control on the CD
receiver.

Selecting the Input Source

To select the input source, press the remote controller's
[INPUT SELECTOR] button. On the CD receiver, press
the [INPUT] button repeatedly. The input sources are
selected in the following order.
(CD receiver)
→ →
CD LINE1
← ←
AM
FM
DAB
(Remote controller)
[LINE]:
OPTICAL ↔ COAXIAL
[DIGITAL]:
FM ↔
[TUNER]:
16
→ →
LINE2 AUX IN
← ←
USB COAXIAL OPTICAL
→
LINE1 LINE2
→
AUX IN
AM
DAB

Adjusting the Tone

1 Press the [TONE] button repeatedly.
Setting will change in the following orders:
Bass, Treble, Balance, PM.Bass, Direct
2 Use the Arrow [ ]/[ ] buttons to adjust the
tone.
Bass, Treble
–3 to 0 to +3 in 1 steps. (The default value is 0.)
Balance
L7 to 0 to R7 in 1 steps. (The default value is 0.)
PM.Bass (Phase Matching Bass)
From the warm low notes produced by a cello to the
deep frequencies of electronic music, a good
compact audio system should be able to deliver
plenty of bass resonance.
While traditional enhancement systems effectively
boost low-frequency sound, they are often prone to
the effects of phase shifting, which can overwhelm
mid-range frequencies and muddy the sound. Our
Phase-Matching Bass Boost technology effectively
preserves mid-range clarity-allowing vocals and
strings to shine-while maintaining a smooth,
powerful bass response at all volume levels.
When the Phase Matching Bass function is on, the
S.Bass indicator appears on the display.
On
Off (default)
Note:
• If the PM.Bass function is set to "On", "Direct"
function cannot be selected. You need to set the
PM.Bass function to "Off" to enable "Direct"
function.
Direct
When the Direct function is on, the tone controls are
bypassed, so you can enjoy a pure sound.
The DIRECT indicator appears on the display.
On
Off (default)
Note:
• If the Direct function is set to "On", the "Bass",
"Treble" and "PM.Bass" functions cannot be
selected. You need to set the Direct function to
"Off" to enable those settings.