Table of Contents
Advertisement
F
P
RONT
ANEL
CLAR/GRP Switch
This button has two functions.
Press this button briefly, the [ CLAR/VFO-B ] knob
will be enabled as an "offset tuning" control to allow
tuning away from the VFO-A frequency, and the
[ CLAR/GRP ] button will glow red.
Pressing and holding this button for one second, al-
lows you to select the memory group using the
[ CLAR ( VFO-B )] knob, and the [ CLAR/GRP ] but-
ton will glow yellow.
BAND MCH Switch
This button has two functions.
Pressing this button briefly, enables the [ CLAR ( VFO-
B )] knob to select the VFO-A operating Amateur Band.
The [ CLAR/GRP )] button glows red.
Pressing and holding this button for one second, al-
lows you to select the memory channel using the
[ CLAR ( VFO-B )] knob, and the [ CLAR/GRP ] but-
ton is glows yellow.
A/B Switch
This button switches the actions of the [ CLAR ( VFO-
B )] knob between VFO-A and VFO-B.
Pressing this button once causes the button to glows
yellow; in this case, rotation of the [ CLAR ( VFO-B )]
knob affects operation on VFO-B (tuning, etc.). Press-
ing this button once more causes the button to turn off;
in this instance, rotation of the [ CLAR ( VFO-B )] knob
affects operations associated with the VFO-A (Clari-
fier function, etc.).
Page 26
C
ONTROLS
& S
WITCHES
VFO-B RX Indicator/Switch
This is the button that turns the VFO-B receiver "On"
and "Off". When the VFO-B receiver is active, the
button will glow green. Pressing this button again will
disable VFO-B receiver, and the imbedded green LED
will turn off. Press and hold in this button for two sec-
onds to activate the VFO Traking feature.
VFO-B TX Indicator/Switch
This button turns the VFO-B transmitter "On" and
"Off". When this button is pressed, it will glow red
and VFO-B will control the transmitter frequency and
mode. Pressing this button once more will transfer fre-
quency/mode control back to VFO-A, and the red LED
in the button will turn off.
CLAR VFO-B Knob
The function of this knob differs according to the set-
tings of the three switches located above the knob. See
the next page for details.
SUB DISPLAY-
This OLED (Organic Light Emitting Diode) display
shows the characteristics of the VFO-A receiver DSP
functions selected by five of the buttons located below
of this display. The ( VFO-A )[ SELECT ] knob located
below this window is an adjustment knob for the func-
tion displayed in this window. Alternately, when the
Menu Mode is activated, this OLED displays the se-
lected Menu item.
FT
5000 O
DX
M
PERATING
ANUAL
Advertisement
Table of Contents
