Configuring In Bindery Mode With Pconsole - Gestetner 1502 Owner's Manual

4.2 Configuring NetWare Bindery Emulation
If you entered a new string in
6.
the
The command at the console prompt takes effect immediately. The definition in
Note:
autoexec.ncf

4.2.2 Configuring in Bindery Mode with PCONSOLE

Once you confirm the server has Bindery Context, use the following procedures to
configure the Network Interface Board.
To configure the Network Interface Board with PCONSOLE:
Log in as a supervisor or ADMIN.
1.
At the command prompt, enter the PCONSOLE command.
2.
Press the F4 key to switch to Bindery mode.
3.
If you receive a message asking you to log in to a server with Bindery connections, the
Note:
server you are attached to does not have Bindery Mode enabled. Follow the steps in
Section 4.2.1 Confirming Bindery Context or log in to a server with Bindery Services
activated.
Choose Quick Setup from the Available Options list.
4.
5. Use Quick Setup to connect your print server, print queue, and printer correctly.
You can modify these later if necessary.
Select Print Server and press F3 or Insert to modify the entry.
6.
Enter the name of the print server in the Print Server field.
7.
The print server name appears under Novell Network Information on the Status
and Configuration report. The default name is the Network Interface Board serial
number (six digits with a three-letter prefix).
Enter a name in the New Printer field.
8.
Enter a name in the New Print Queue field.
9.
In the Printer Type field, choose Other/Unknown from the list of printer types.
10.
When you are finished, press Esc to save the configuration.
11.
4-8
SET BINDERY CONTEXT
takes effect when the server is restarted.
, then at the console prompt, enter
autoexec.ncf
statement that you entered in the file.
NetWare Configuration