Enabling/Disabling Network Protocols; Restoring Factory Defaults; Changing A Password; Exiting Telnet - Gestetner 1502 Owner's Manual

7.7 Running Telnet

7.7.4 Enabling/Disabling Network Protocols

To enable network protocols, type 3 at the main menu.
You are given the choice of disabling either NetWare or AppleTalk since both network
OSs are enabled by default. For example, to disable Appletalk, type 2 and press Enter.

7.7.5 Restoring Factory Defaults

When you need to restore factory defaults on your print server, type 4 at the Main Menu
and press Enter. All NVRAM stored parameters are returned to their factory default
values. The factory default values do not take effect until you exit the Telnet program or
the unit is powered off and on.

7.7.6 Changing a Password

Type 5 at the main menu.
1.
Type up to eight characters at the New Password query and press Enter.
2.
3. Retype the same characters at the Retype New Password query and press Enter.
Choose the Save Changes and Exit option.
4.
Once you have set your password, the sysadm password is no longer valid.
There is a single maintenance access password to the Network Interface Board. You
Note:
use this password with Telnet or when accessing the Network Interface Board HTML
pages with MAP or a Web browser.

7.7.7 Exiting Telnet

Type E at the main menu.
1.
If you have made any changes, the exit menu is displayed:
7-16
Exit
1. Save Changes and Exit
2. Save Changes and Reset
3. Exit Without Saving Changes
TCP/IP Configuration