Table of Contents
Advertisement
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[BNC]
[SERIAL]
Note
f [BNC] and [SERIAL] cannot be used simultaneously within the linked projectors.
[RS-232C]
Set the communication condition of the <SERIAL IN>/<SERIAL OUT> terminal. For details on the connection
method for RS-232C communication, refer to "<SERIAL IN>/<SERIAL OUT> terminal" (x page 239).
Setting the communication condition of the <SERIAL IN> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [INPUT SELECT].
4)
Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5)
Press as to select [(IN) BAUDRATE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7)
Press as to select [(IN) PARITY].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Setting the communication condition of the <SERIAL OUT> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [(OUT) BAUDRATE].
4)
Press qw to switch the item.
[9600]
[19200]
[38400]
5)
Press as to select [(OUT) PARITY].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses the <MULTI PROJECTOR SYNC IN>/<MULTI PROJECTOR SYNC OUT> terminals (BNC).
Uses the <SERIAL IN>/<SERIAL OUT> terminals.
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK> terminal.
Select the proper speed.
Select the parity condition.
Select the proper speed.
ENGLISH - 161
Advertisement
Table of Contents
