Replacing The Air Filter - Sharp XG-P25XU Operation Manual

Replacing the Air Filter

• This projector is equipped with two air filters to ensure the optimal operating condition of the projector.
• The air filters should be cleaned every 100 hours of use. Clean the filters more often when the projector is used
in a dusty or smoky location.
• Have your nearest Sharp Authorized LCD Projector Dealer or Service Center exchange the filter (PFILD0080CEZZ)
when it is no longer possible to clean it.
Bottom View
Air filter
Cleaning and replacing the bottom air filter
Turn off the power and
1
disconnect the power
cord.
Press POWER OFF. Wait until
the cooling fan stops.
4
Clean the air filter.
Clean the dust off the air filter
and cover with a vacuum
cleaner extension hose.
• Be sure the filter cover is securely installed. The power will not turn on unless it is correctly installed.
Cleaning the side air filter (not removable)
If dust or dirt has collected inside the air filter, clean the filter with a vacuum cleaner extension hose.
• The side air filter cannot be removed.
XG-P25X/CD (E)-g 64
Side and Rear View
2 Remove the bottom
filter cover.
Turn over the projector. Press the
tab and lift open the filter cover
in the direction of the arrow.
5
Replace the air filter.
Place the air filter underneath
the tabs on the filter frame.
Air filter (not removable)
3 Remove the air filter.
Grasp the air filter between your
fingers and lift it out of the filter
cover.
Tab
6 Replace the filter
cover.
Insert the tab on the end of the
filter cover into the filter cover
opening and press the filter
cover into position.
02.3.19, 7:12 PM
Tab
E-64