Advertisement
Problem
The battery of the
remote control runs
empty too fast.
The robot is moving in
circles.
The robot cannot find the
docking station.
Possible cause
Perhaps you did not insert
the correct type of battery.
The robot is in spot-cleaning
mode.
There is not enough room for
the robot to navigate
towards the docking station.
The robot is still actively
searching.
The robot was not started
from the docking station.
Solution
For the remote control, you need a
CR2025 coin-shaped battery. If the
problem persists, go to
www.philips.com/support or contact the
Consumer Care Center in your country.
This is normal behavior. The spot-cleaning
mode can be activated when a lot of dirt
is detected on the floor for a thorough
clean. It is also part of the auto cleaning
mode. After approximately one minute
the robot resumes its normal cleaning
pattern. You can also stop the spot-
cleaning mode by selecting a different
cleaning mode on the remote control.
Try to find another place for the docking
station. See 'Installing the docking station'
in chapter 'Preparing for use'.
Give the robot around 20 minutes to
return to the docking station.
If you want the robot to return to the
docking station after a cleaning run, start
it from the docking station.
English
15
Advertisement
