Download Print this page

Removing The Rechargeable Battery; Troubleshooting - Philips FC8772 Manual

Hide thumbs Also See for FC8772:

Advertisement

Replacing the battery of the remote control
The remote control works on a CR2025 coin-shaped battery. Replace the battery when the robot no
longer responds when you press the buttons on the remote control.
1 Hold the remote control upside down. Push the release button on the battery holder and at the
same time slide the battery holder out of the remote control (Fig. 47).
2 Remove the empty battery from the battery holder and place a new battery in the battery holder.
Then slide the battery holder back into the remote control (Fig. 48).

Removing the rechargeable battery

Warning: Only remove the rechargeable battery when you discard the appliance. Make
sure the battery is completely empty when you remove it.
To remove the rechargeable battery, follow the instructions below. You can also take the robot to a
Philips service center to have the rechargeable battery removed. Contact the Philips Consumer Care
Center in your country for the address of a service center near you.
1 Start the robot from a place somewhere in the room and not from the docking station.
2 Let the robot run until the rechargeable battery is empty to make sure that the rechargeable
battery is completely discharged before you remove it and dispose of it.
3 Undo the screws of the battery compartment lid and remove the lid (Fig. 49).
4 Lift out the rechargeable battery and disconnect it (Fig. 50).
5 Take the robot and the rechargeable battery to a collection point for electrical and electronic
waste.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The robot does not start
cleaning when I press the
start/stop button.
The robot does not
respond when I press
one of the buttons.
The warning indicator
flashes quickly.
Possible cause
The rechargeable battery is
empty.
The robot is in deep sleep
mode.
The robot's rechargeable
battery is empty'.
One or both wheels are
stuck.
One or both side brushes are
stuck.
Solution
Charge the rechargeable battery (see
chapter 'Preparing for use').
Press the start/stop button once to
reactivate the robot.When you press the
start/stop button again the robot starts
cleaning. If the rechargeable battery is
empty,place the robot on the plugged-in
docking station.
Place the robot on the plugged-in
docking station. After a few seconds, the
robot beeps and the display lights up.
Remove the fluff, hair, thread or wire that
is caught around the wheel suspension.
Clean the side brushes (see chapter
'Cleaning and maintenance').
English
13

Advertisement

loading

This manual is also suitable for:

Fc8776Fc8774Fc8972Fc8776/82