Philips FC8776 Important Safety Information

Philips FC8776 Important Safety Information

Hide thumbs Also See for FC8776:

Advertisement

Quick Links

FC8776

Advertisement

Table of Contents
loading

Summary of Contents for Philips FC8776

  • Page 1 FC8776...
  • Page 5 English 6...
  • Page 6: Important Safety Information

    English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Important safety information Read this important information carefully before you use the appliance and save it for future reference.
  • Page 7 - Do not use the robot in a room with a temperature above 45 °C. - The rechargeable battery may only be replaced by qualified service engineers. Take the robot to an authorized Philips service center to have the battery replaced when you can no longer recharge it or when it runs out of power quickly.
  • Page 8 - Do not use the robot on high-pile carpets or on rugs with tassels. - Do not clean the dust container and the filter with water or in the dishwasher. Electromagnetic fields (EMF) This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.
  • Page 9: General Description (Fig. 1)

    English General description (Fig. 1) Top cover 2 Handle of dust container lid 3 Dust container lid 4 Filter 5 Dust container 6 Fan 7 Bumper 8 Docking station sensor 9 Start/stop button (to start or stop the robot) 10 Display 11 TriActive XL nozzle 12 Front wheel 13 Side brush shafts...
  • Page 10: Before First Use

    English Cleaning patterns In its auto cleaning mode, the robot uses an automatic sequence of cleaning patterns to clean each area of the room optimally. The cleaning patterns it uses are: Z-pattern or zigzag pattern (Fig. 5) 2 Random pattern (Fig. 6) 3 Wall-following pattern (Fig.
  • Page 11 English Important note: deep sleep mode In deep sleep mode, the robot does not respond at all when you press a button. To reactivate the robot when it is in deep sleep mode: 1 Press the start/stop button on the robot to bring the robot from deep sleep mode to standby mode.
  • Page 12: Using Your Robot

    English What to do if WiFi setup fails If no WiFi connection is established after 1 minute, the device enters access point mode and waits for a new attempt to set up the connection. For iPhones: 1 Open system setup and choose 'WiFi LAN'. 2 Select the access point starting with 'alink_PHILIPS'.
  • Page 13: Cleaning And Maintenance

    English Signal Meaning The start/stop button flashes slowly. The robot is charging. The start/stop button flashes quickly. The robot is is searching for the docking station. The rechargeable battery of the robot is low. The WiFi connection indicator flashes slowly. The robot is in WiFi setup mode.
  • Page 14 Replacement Ordering accessories To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details). Replacing the filter Replace the filter if it is very dirty or damaged.
  • Page 15: Warranty And Support

    Philips service center to have the battery replaced when you can no longer recharge it or when it runs out of power quickly. You can find the contact details of the Philips Consumer Care Center in your country in the international warranty leaflet or on the website at www.philips.com/support.
  • Page 16: Troubleshooting

    This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Center in your country.
  • Page 17 The rechargeable battery has Have the rechargeable battery replaced can no longer be charged reached the end of its life. by a Philips service center (see chapter or runs empty very fast. 'Replacement'). The battery of the Perhaps you did not insert...
  • Page 18 English Problem Possible cause Solution The robot was not started If you want the robot to return to the from the docking station. docking station after a cleaning run, start it from the docking station.
  • Page 22 1 0 0...
  • Page 26 4222.003.4339.1 6/5/2019 > 75% 循环再造纸 保留备用 >75 % recycled paper >75 % papier recyclé...

Table of Contents