Using The Appliance; Brushing Instructions - Philips Sonicare HealthyWhite+ HX8962/05 Manual

Note: It can take up to 48 hours to fully charge the battery, but the
Philips Sonicare may be used before it is fully charged.

Using the appliance

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
(45 degrees), pressing firmly to make the bristles reach the gumline
or slightly beneath the gumline (Fig. 7).
Note: Keep the center of the brush in contact with the teeth at all
times.
3 Press the power on/off and mode button to turn on the Philips
Sonicare.
4 Apply light pressure to maximize Philips Sonicare's effectiveness
and let the Philips Sonicare toothbrush do the brushing for you.
Do not scrub.
5 Gently move the brush head slowly across the teeth in a small
back and forth motion so the longer bristles reach between your
teeth. Continue this motion throughout the brushing cycle.
6 To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth (Fig. 8).
Note: To make sure you brush evenly throughout the mouth, divide
your mouth into 4 sections using the Quadpacer feature (see chapter
'Features').
7 Begin brushing in section 1 (outside upper teeth) and brush for
30 seconds before you move to section 2 (inside upper teeth).
Continue brushing in section 3 (outside lower teeth) and brush for
30 seconds before you move to section 4 (inside lower teeth (Fig. 9)).
35_020_9633_2_DFU-Simple_A6_v1.indd 9
9
English
08/12/15 08:47