Preparing For Use; Attaching The Brush Head; Charging The Appliance; Using The Appliance - Philips Sonicare HX6284/64 Manual

8
English
6 Charger
- Not shown: Travel case
Note: The content of the box may vary based on the model
purchased.
Note: Brush head type may vary based on the model purchased
(different appearance as the picture shown here)

Preparing for use

Attaching the brush head

1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 2).
2 Firmly press the brush head down onto the metal shaft until it
stops.
Note: Philips Sonicare brush heads are imprinted with icons to easily
identify your brush head (Fig. 3).

Charging the appliance

1 Plug the charger into an electrical outlet.
2 Place the handle on the charger (Fig. 4).
- The battery level indicator flashes to indicate that the toothbrush
is charging. When the light stops flashing and turns solid green the
toothbrush is fully charged. (Fig. 5)
Note: It can take up to 48 hours to fully charge the battery, but the
Philips Sonicare may be used before it is fully charged.

Using the appliance

Brushing instructions

1 Press the brush head onto the handle aligning the brush head. The
bristles will face the front of the handle. (Fig. 2)
2 Rinse your mouth with water and vigorously swish away any
particles.
3 Wet the bristles and apply a small amount of toothpaste.
4 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline. (Fig. 6)