Tools You Will Need; Normal Installation Steps; Anti-Tip Bracket Installation Instructions Important; Safety Warning - Frigidaire FPGH3077R Installation Instructions Manual

30" GAS RANGE INSTALLATION INSTRUCTIONS

Tools you will need

For leveling legs and anti-tip brackets:
● Adjustable wrench or channel
lock pliers
● 5/16" Nutdriver or Flat Head
Screw Driver
● Electric Drill & 1/8 Diameter
Drill Bit (5/32" Masonry Drill
Bit if installing in concrete)
● Level & Measuring Tape
For gas supply connection:
● Pipe Wrench
● Brush
For burner fl ame adjustment
● Phillips head
screwdrivers
For gas conversion (LP/Propane or Natural):
● Open end wrench - 1/2"
Additional materials you will need
● Gas line shut-off valve
● Pipe joint sealant that resists action of LP/ Propane
gas
● A new fl exible metal appliance conduit
(½" NPT x ¾" or ½" I.D.) must be design
certifi ed by CSA International. Because
solid pipe restricts moving the range we
recommend using a new fl exible conduit
(4 feet length) for each new installation
and additional reinstallations.
● Always use the (2) new fl are union
adapters ½" NPT x ¾" or ½" I.D.) supplied
with the new fl exible appliance conduit for
connection of the range.

Normal Installation Steps

1
Anti-tip Bracket Installation Instructions
Important Safety Warning
To reduce the risk of tipping of the range, the range must be
secured to the fl oor by the properly installed anti-tip bracket
and screws packed with the range. Failure to install the anti-
tip bracket will allow the range to tip over if excessive weight
is placed on an open door or if child climbs upon it. Serious
injury might result from spilled hot liquids or from the range
itself.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the range.
and blade-type
Instructions are provided for installation in wood or
cement fl oor. When fastening to fl oor, be sure that
screws do not penetrate electrical wiring or plumbing.
Tip Over Hazard
• A child or adult can tip the range and
be killed.
• Verify the anti-tip device has been
installed to fl oor or wall as per
installation instructions.
• Ensure the anti-tip device is re-engaged to fl oor or
wall when the range is moved.
• Do not operate the range without the anti-tip device
in place and engaged.
• Failure to follow these instructions can result in
death or serious burns to children and adults.
Range
Leveling
Leg
To check if the anti-tip bracket is installed properly,
use both arms and grasp the rear edge of range back.
Carefully attempt to tilt range forward. When properly
installed, the range should not tilt forward.
A. Locate the Bracket Using the Template -
Locate the bracket position (right or left side) by placing
the template symmetrically to the center of the fi nal
range position. Mark the location of the screw holes,
shown on template.
4
Anti-Tip
Bracket
Figure 1