Air Shutter-Broil Burner; Make Sure Range Is Level; After Installation Is Complete Make Sure All Controls Are Left In The Off Position; Lp/Propane Gas Conversion - Frigidaire FPGH3077R Installation Instructions Manual

Front control 30" gas range
Hide thumbs Also See for FPGH3077R:
Table of Contents

Advertisement

Available languages

Available languages

30" GAS RANGE INSTALLATION INSTRUCTIONS
10

Air Shutter-Broil Burner

The approximate fl ame length from the burner is 1 inch
(distinct inner cone of blue fl ame).
To determine if the broil burner fl ame is proper, set the
oven to broil.
If fl ame is yellow in color, increase air shutter opening
size (see "2" in Figure 8 ). If the entire fl ame is blue,
reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in Figure 8),
reposition air shutter, and tighten lock screw.
Lock
3
Screw
2
Figure 8
11

Make sure range is level

Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by adjusting the leveling legs.
12
After installation is completed, make sure
all controls are left in the OFF position.

LP/Propane Gas Conversion

This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
If you wish to convert your range for use with LP/
Propane gas, use the supplied fi xed orifi ces located
in a bag containing the literature marked "FOR
LP/PROPANE GAS CONVERSION." Follow the
instructions packaged with the orifi ces for surface,
oven and broil burners conversion.
The conversion must be performed by a qualifi ed
service technician in accordance with the
manufacturer's instructions and all local codes and
requirements. Failure to follow these instructions
could result in serious injury or property damage.
The qualifi ed agency performing this work assumes
responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
Oven Burner Tube
1
Orifi ce Hood
10

Care, Cleaning and Maintenance

Refer to the Use & Care Guide for cleaning
instructions.
If moving the range is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the
gas and electrical supply. If gas or electrical supply is
inaccessible, lift the unit slightly at the front and pull out
away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish moving the unit for servicing
and cleaning. Reinstall in reverse order making sure to
level the range and check gas connections for leaks.

Before You Call for Service

Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
Serial Plate Information
The serial plate is located as shown. See the serial
plate for the following information:
A. Model, lot and serial number of range.
B. Kilowatt rating (power requirements).
C. Voltage ratings.

Advertisement

Table of Contents
loading

Table of Contents