Tools You Will Need; Anti-Tip Bracket Installation Instructions - Frigidaire PCFI308CAF Installation Instructions Manual

30" ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

2. Tools You Will Need

For leveling legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock
pliers
• 5/16" Nutdriver or Flat Head
Screwdriver
• Electric Drill & 1/8" Diameter
Drill Bit (Masonry Drill Bit if
installing in concrete)
• Level & Measuring Tape
For electrical supply connection:
• 1/4" & 3/8" Socket driver or Nutdriver
Additional Materials You Will Need:
• Power Supply Cord or
• Copper Electrical Wiring & Metal
Conduit (for hard wiring)
3. Anti-Tip Bracket Installation
Instructions
To reduce the risk of tipping of the range,
the range should be secured to the floor by properly
installed anti-tip bracket and screws packed with the
range. Failure to install the anti-tip bracket will allow the
range to tip over if excessive weight is placed on an open
door or if a child climbs upon it. Serious injury might result
from spilled hot liquids or from the range itself.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement
fastened to either the floor or wall. When installed to the
wall, make sure that screws completely penetrate dry wall
and are secured in wood or metal. When fastening to the
floor or wall, be sure that screws do not penetrate electrical
wiring or plumbing.
A. Locate the Bracket Using the Template - (Bracket may
be located on either the left or right side of the range.
Use the information below to locate the bracket if
template is not available). Mark the floor or wall where
left or right side of the range will be located. If rear of
range is against the wall or no further than 1-13/16"
(46 mm) from wall when installed, you may use the
wall or floor mount method. If molding is installed and
does not allow the bracket to fit flush against the wall,
remove molding or mount bracket to the floor. For wall
mount, locate the bracket by placing the back edge of
the template against the rear wall and the side edge
of template on the mark made referencing the side of
the range. Place bracket on top of template and mark
location of the screw holes in wall.
If rear of range is further than 1-13/16" (46 mm) from
the wall when installed, attach bracket to the floor. For
floor mount, locate the bracket by placing back edge
of the template where the rear of the range will be
located. Mark the location of the screw holes, shown
in template.
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
(3 mm) pilot hole where screws are to be located. If
bracket is to be mounted to the wall, drill pilot hole at
an approximate 20° downward angle. If bracket is to
be mounted to masonry or ceramic floors, drill a 5/32"
(4 mm) pilot hole 1-3/4" (44 mm) deep. The screws
provided may be used in wood or concrete material.
Use a 5/16" (8 mm) nut-driver or flat head screwdriver
to secure the bracket in place.
3
Fig. 4
More than
1-13/16"
(45.6 mm)
Fig. 5
1-13/16" Max.
(45.6 mm)
Fig. 6