Fig 9. The above curves illustrates the effect of the 'bass tilt',
Fig 9. The above curves illustrates the effect of the 'bass tilt',
Fig 9. The above curves illustrates the effect of the 'bass tilt',
Fig 9. The above curves illustrates the effect of the 'bass tilt',
Fig 9. The above curves illustrates the effect of the 'bass tilt',
'bass roll-off' and 'bass',' mid' and 'treble' level controls on the
'bass roll-off' and 'bass',' mid' and 'treble' level controls on the
'bass roll-off' and 'bass',' mid' and 'treble' level controls on the
'bass roll-off' and 'bass',' mid' and 'treble' level controls on the
'bass roll-off' and 'bass',' mid' and 'treble' level controls on the
free field response, measured at 2 m.
free field response, measured at 2 m.
free field response, measured at 2 m.
free field response, measured at 2 m.
free field response, measured at 2 m.
SYSTEM SPECIFICATIONS
SYSTEM SPECIFICATIONS
SYSTEM SPECIFICATIONS
SYSTEM SPECIFICATIONS
SYSTEM SPECIFICATIONS
Lower cut-off frequency, -3 dB:
Upper cut-off frequency, -3 dB:
Free field frequency response of system:
33 Hz - 20 kHz (± 2.5 dB)
Maximum short term sine wave acoustic output
on axis in half space, averaged from 100 Hz to 3
kHz:@ 1m
> 123 dB SPL
Maximum long term RMS acoustic output in
same conditions with IEC-weighted noise
(limited by driver unit protection circuit):
@ 1m > 118 dB SPL
Maximum peak acoustic output per pair @ 2m
from the engineer with music material:
> 125 dB
Self generated noise level in free field @ 2m on
axis:
< 15 dB(A)
Harmonic distortion at 100 dB SPL @ 1m on axis:
Freq: 50...200 Hz
200...10k Hz <0.5%
Drivers:
Bass
2 x 305 mm (12") cone
Mid
1 x 130 mm (5") cone
Treble
1 x 25 mm (1") metal dome
Weight:
Speaker
73 Kg
Amplifier
30 Kg
Speaker dimensions (Horizontal mounting):
Height
700 mm
Width
890 mm
Depth
383 mm
Amplifier dimensions:
Height
310 mm
Width
483 mm
Depth
250 mm
*Note that the cable connectors require
additional 100 mm (4") of space behind both the
amplifier and the speaker cabinet
Genelec Oy, Olvitie 5
Genelec Oy, Olvitie 5
Genelec Oy, Olvitie 5
Genelec Oy, Olvitie 5
Genelec Oy, Olvitie 5
FIN - 74100 IISALMI, FINLAND
FIN - 74100 IISALMI, FINLAND
FIN - 74100 IISALMI, FINLAND
FIN - 74100 IISALMI, FINLAND
FIN - 74100 IISALMI, FINLAND
Phone:
Phone:
Phone:
Phone:
Phone:
+358 17 813311
+358 17 813311
+358 17 813311
+358 17 813311
+358 17 813311
Telefax:
Telefax: +358 17 812267
Telefax:
+358 17 812267
+358 17 812267
+358 17 812267
Telefax:
Telefax:
+358 17 812267
E-mail:
E-mail:
E-mail:
E-mail:
E-mail:
genelec@genelec.com
genelec@genelec.com
genelec@genelec.com
genelec@genelec.com
genelec@genelec.com
Web:
Web:
Web:
Web:
Web:
http://www.genelec.com
http://www.genelec.com
http://www.genelec.com
http://www.genelec.com
http://www.genelec.com
AMPLIFIER SECTION
AMPLIFIER SECTION
AMPLIFIER SECTION
AMPLIFIER SECTION
AMPLIFIER SECTION
< 32 Hz
Bass amplifier output power with an 8 Ohm load:
Short term
> 20 kHz
Mid amplifier output power with a 8 hm load:
Short term
Treble amplifier output power with an 8 Ohm
load:
Short term
Long term output power is limited by driver unit
protection circuitry.
Slew rate:
Amplifier system distortion at nominal output:
Signal to Noise ratio, referred to full output:
<1%
Mains voltage: 100/200 or 115/230V
Voltage operating range at
230V setting: 207 - 244 V (-10/+6 %)
115V setting: 104 - 122 V (-10/+6 %)
Power consumption:
(161 lb)
Idle
(66 lb)
Full output
9
(27
/
")
16
(35")
(15")*
3
(12
/
")
16
(19")
13
(9
/
")*
16
Fig 10. The upper curve group shows the horizontal directivity
Fig 10. The upper curve group shows the horizontal directivity
Fig 10. The upper curve group shows the horizontal directivity
Fig 10. The upper curve group shows the horizontal directivity
Fig 10. The upper curve group shows the horizontal directivity
characteristics of the 1034B in its horizontal configuration mea-
characteristics of the 1034B in its horizontal configuration mea-
characteristics of the 1034B in its horizontal configuration mea-
characteristics of the 1034B in its horizontal configuration mea-
characteristics of the 1034B in its horizontal configuration mea-
sured at 2m. The lower curve is a 1/6 octave power response
sured at 2m. The lower curve is a 1/6 octave power response
sured at 2m. The lower curve is a 1/6 octave power response
sured at 2m. The lower curve is a 1/6 octave power response
sured at 2m. The lower curve is a 1/6 octave power response
measurement, derived from 144 directivity measurements.
measurement, derived from 144 directivity measurements.
measurement, derived from 144 directivity measurements.
measurement, derived from 144 directivity measurements.
measurement, derived from 144 directivity measurements.
2 x 400 W
350 W
120 W
80 V/µs
THD
<0.05%
SMPTE-IM
<0.05%
CCIF-IM
<0.05%
DIM 100
<0.05%
Bass
>100 dB
Mid
>100 dB
Treble
>100 dB
70 W
1000 W
CROSSOVER SECTION
CROSSOVER SECTION
CROSSOVER SECTION
CROSSOVER SECTION
CROSSOVER SECTION
Input connector: XLR female
Input impedance: 10 kOhm balanced
Input level for 100 dB SPL output @ 1m:
variable from +6 to -6 dBu
Input level for maximum short term output of 126
dB SPL @ 1m:
variable from +32 to +20 dBu
Subsonic filter below 27 Hz :
18 dB/octave
Ultrasonic filter above 22 kHz:
12 dB/octave
Crossover frequencies:
Bass/Mid
Mid/Treble
Crossover acoustical slopes:
>24 dB/octave
Level control operating range in 1 dB steps:
Bass
from 0 to -6 dB & MUTE
Mid
from 0 to -6 dB & MUTE
Treble
from 0 to -6 dB & MUTE
Bass roll-off control in 2 dB steps:
from 0 to -8 dB @ 29 Hz
Bass tilt control operating range in 2 dB steps:
from 0 to -8 dB @ 50 Hz
The 'CAL' position is with all tone controls set to
'off' and input sensitivity control to maximum and
corresponds to a maximally flat free field
response.
Genelec Document DR34001
Genelec Document DR34001
Genelec Document DR34001
Genelec Document DR34001
Genelec Document DR34001
COPYRIGHT GENELEC OY 1998
COPYRIGHT GENELEC OY 1998
COPYRIGHT GENELEC OY 1998
COPYRIGHT GENELEC OY 1998
COPYRIGHT GENELEC OY 1998
All data subject to change without prior notice
All data subject to change without prior notice
All data subject to change without prior notice
All data subject to change without prior notice
All data subject to change without prior notice
pin 1
gnd
pin 2
+
pin 3
-
400 Hz
3.2 kHz
Need help?
Do you have a question about the 1034B and is the answer not in the manual?