SPL’s and extended low frequency response are essential. The 1034B is designed to be flush mounted in the control room wall. The electronics are housed in a standard 7U 19” equipment rack.
Page 3
Figure 2: Block diagram of the 1034B Figure 3: The upper curve group shows the horizontal directivity characteristics of the 1034B in its vertical configuration measured at 2 m. The lower curve is a 1/6 octave power response measurement, derived from 144 individual directivity measurements.
Page 4
* Note that the cable connectors require additional 100 mm (4”) of space behind both the amplifier and the speaker cabinet. Genelec Document BBA34001c. Copyright Genelec Oy 5.2006. All data subject to change without prior notice AmpliFier Section Bass amplifier output power with...
Need help?
Do you have a question about the 1034B and is the answer not in the manual?
Questions and answers