Ec Declaration Of Conformity - Genelec 7260A Operating Manual

INTRODUCTION
Congratulations and a thank-you for the purchase of this Genelec 700 Series DSP Subwoofer. These
systems are designed to integrate easily into the digital production environment. There are several ways
to configure and operate the DSP subwoofers for a wide variety of high quality audio applications.
This manual addresses setting up and using the Genelec 760A, 770A and 771A subwoofers with
Genelec 840A and 850A DSP loudspeakers in stand-alone mode without the Genelec Loudspeaker
Manager GLM™ and the proprietary Genelec loudspeaker control network. Use with the GLM™ network
is described in the DSP System Operating Manual.

EC Declaration Of Conformity

This is to certify that Genelec 760A, 770A and 771A DSP subwoofers conform to the following
standards:
Safety: EN 60065: 00 / IEC 60065:001 7th Edition
EMC: EN 5500 : 00 + A1 : 00, EN 5501: (001), EN 61000-- (000) and EN 61000-- (1995)
The products herewith comply with the requirements of The Low Voltage Directive 7//EEC, EMC
Directive 89/6/EEC and 9/68/EEC
Signed:
Ilpo Martikainen
Position: Chairman of the Board
Date: 0-February-006
Compliance to FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against