Advertisement

7040A
Operating Manual
Genelec 7040A
Active Subwoofer

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7040A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Genelec 7040A

  • Page 1 7040A Operating Manual Genelec 7040A Active Subwoofer...
  • Page 2: Installation

    In those environments where and manufactured with care in our factory, The subwoofer sensitivity can be the 7040A is required to be on all of the in Finland, using environmentally efficient adjusted from +12 to -6 dBu to match the...
  • Page 3: Positioning In The Room

    LEFT OUT RIGHT OUT 100 - 240 V~ POWER SWITCH Figure 1. 7040A's amplifier panel, connectors and controls. Audio connections to the subwoofer First, place the subwoofer slightly offset and monitors use balanced XLR cables from the center of the front wall. The dis-...
  • Page 4: Setting The Input Sensitivity

    LEFT IN or RIGHT IN input of the measurement system, adjust the sensitiv- side (opposite of the connector panel) should 7040A and feed in an 85 Hz tone. Connect ity of the subwoofer until the frequencies have a minimum clearance of 7.5 cm (3 in).
  • Page 5: Safety Considerations

    • Connect the equipment into an outlet harmonic distortion analysis of the 7040A in free field. In half space the SPL sound pressure levels in excess of 85 on a circuit different from that to which will be 6 dB higher.
  • Page 6 0 to -270° Input sensitivity control +12 to -6 dBu www.genelec.com Genelec Document D0126R001a Copyright Genelec Oy 9.2016. All data subject to change without prior notice International enquiries: In Sweden please contact In the U.S. please contact: In China please contact:...

Table of Contents