This manual addresses setting on the chosen mode of bass management, (100-240 VAC, 50-60 Hz) and enables the up and using the Genelec 7360A and 7370A these outputs may carry either unfiltered or subwoofer to be plugged in anywhere subwoofers.
Page 3
3D immersive setups including when a computer is not in use. Genelec • Connect a CAT5 (RJ45) cable between also one or more subwoofers. GLM setup is...
Page 4
150 Hz (see also "LFE CHANNEL" below). Connector Panel Light Cabling LFE CHANNEL A/B selects which The 7300 series subwoofers can be easily set Normally, the light on the connector panel is up using the fixed 85 Hz analogue crossover subframe in the "AES/EBU DIGITAL IN"...
Manual Phase Additional Information Adjustment Method Positioning Subwoofer in Room Genelec 7360A and 7370A subwoofers are equipped with a built-in 85 Hz frequency The location of the subwoofer can affect test tone generator for phase alignment. the frequency response and sound level...
Maintenance or repair must 7360A. 7370A. only be done by a Genelec certified service. Guarantee Genelec guarantees the subwoofers for • Free flow of air behind and around the instructions, may cause harmful interference...
Connection 2 RJ45, CAT5 cables software frequency response adjustment parametric notch filters System calibration Genelec GLM AutoCal™ Crossover subwoofer/subwoofer output channels Centralized Bass Management Subwoofer: low pass 85 Hz, output: high pass 85 Hz Distributed Bass Management (GLM control only)
Page 8
7360A and 7370A Operating Manual Genelec Document D0134R001a. Copyright Genelec Oy 9.2016. All data subject to change without prior notice International enquiries: In Sweden please contact In the U.S. please contact: In China please contact: Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the 7300 Series and is the answer not in the manual?
Questions and answers