Operation; Technical Data - Hans Grohe Metris S2 31160000 Manual

Attention: The fitting must be installed, flushed
and tested after the valid norms.
The mixer can not used together with a continuous
flow water heater.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer
over the threaded pin and tighten the nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the Isiflex hose with the handshower
and the mixer.
Large differences in pressure between the hot and
cold water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
The handshower is activated by pressing the button,
the spout of the mixer is closed. After the button is
released, the handshower is closed und the spout
of the mixer is activated.

Technical Data

Operating pressure:
Recommended operating pressure: 0,25 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow mixer:
Rate of flow handshower:
To adjust the hot water limiter on single lever mixers,
please see page 20.
English
max. 1 MPa
1,6 MPa
max. 80° C
65° C
6,5 l/min 0,3 MPa
8,5 l/min 0,3 MPa
Spare parts (see page 4 - 5)
1 handle Talis S
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 locking screw
6 aerator cpl.
7 fixing set
8 Isiflex hose 1,6 m
9 handshower
10 handle Metris S
11 nut
12 handle Metris E
13 flange
14 fixing set
15 handle Talis E²
16 handle Talis S²
17 chain for plug
18 shower holder
32092000
96338000
96656000
96690000
92730000
96059000
13913000
96016000
28246000
96907000
31093000
97209000
31094000
96656000
97774000
31692000
32096000
97109000
28331000
9