Checking The Blades; Removing The Bioclip Plug - Husqvarna 111B Operator's Manual

2 Fit the cutting deck's pipe together with the deck frame's
pipe.
3 Push the cutting deck in and make sure the guide bolts fit
into the grooves on the deck frame, one on each side.
4 Grab the pipes and push the deck in.
5 Push the deck until you feel the pipes touch bottom. 5 Push the deck until you feel the pipes touch bottom. 5 Push the deck until you feel the pipes touch bottom.
6 Fit the belt according to the picture. 6 Fit the belt according to the picture. 6 Fit the belt according to the picture.
7 Tension the belt with the belt adjuster.
8 Fit the front cover.
Maintenance
9 Set the cutting deck height control in any of the positions
2-6.

Checking the blades

To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
• Put the unit in the service position, see Service position
for the cutting unit.
IMPORTANT INFORMATION IMPOR IMPORTANT INFORMATION TANT INFORMATION
Replacing or shar Replacing or sharpening the blades should be conducted Replacing or shar
by an authorised service workshop. by an authorised service workshop.
by an authorised service workshop.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the servicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
!

Removing the BioClip plug

To change a BioClip deck from the BioClip function to a
cutting deck with rear ejection, remove the BioClip plug, which
is located under the unit, attached with a screws.
1 Put the unit in the service position, see Service position
for the cutting unit.
2 Loosen the screw holding the plug and remove it.
3 Fit cutting unit.
4 Fit the BioClip plug in the reverse order.
WARNING! If the blades are cracked,
whether caused by poor repair or other
damage, they could break while being used.
The risk increases if the blades are poorly
balanced.
– 23
English