Installing Shelves; Electrical System - Summit Appliance Accucold ACR1717 Series Instruction Manual

INSTALLING SHELVES

Your refrigerator contains 6 polycarbonate plastic shelves and 24 shelf clips.
To install shelves, first place the shelf clips in the slots in the pilasters in the cabinet interior. Use the
numbers on the pilasters as a guide in placing the clips at the same distance from the cabinet floor, with
the tab pointing up as shown. Once all clips are in place, install the shelves by placing them on the clips,
with the outside bar of the shelf on the inside of the clip tabs. Keep all stored items inside the limits of the
shelves. These allow airflow and should not be blocked when product is stocked in the unit.

ELECTRICAL SYSTEM

Proper electrical installation is required for your refrigerator to function correctly and to prolong the useful
life of electrical parts and compressor.
IMPORTANT:
•
Do not try to repair any portion of the electrical system yourself. Contact the nearest
authorized service center.
•
The unit must be grounded.
•
Ignoring any of the precautions in this manual invalidates the Warranty.
•
The unit must be connected to a circuit breaker with a 15-ampere fuse and installed
with a minimum 14-caliber wire.
CAUTION: DO NOT STOCK PRODUCT UNTIL SHELVES ARE
CORRECTLY INSTALLED IN THE UNIT WITH SHELF CLIPS.
IMPORTANT: TO AVOID ACCIDENTS WHEN CLEANING INSIDE
OF UNIT, FIRST REMOVE SHELVES AND SHELF CLIPS.
BEFORE CONNECTING UNIT FOR FIRST TIME:
Verify that line voltage does not fluctuate more than
10% above the nominal value of 115 V, 60 Hz.
DO NOT use extension cords.
DO NOT connect refrigerator to multiple plugs or
plugs with another appliance connected.
The unit MUST be plugged into a grounded socket.
8