Table of Contents
Advertisement
6. Unscrew and transfer the door adapter (7) to the opposite position of the door. (Fig. 3)
7. Relocate it to the designated position. Then screw both bottom hinges on the designated positions and
tighten them. (Fig. 5)
8. Recheck and adjust the door alignment by loosening the screws (8) and moving the door adapter (7).
Tighten the screws (8) after the door is levelled. (Fig. 5)
9. Remove the handle from the left side of the door and install it on the right side. (See next section.)
INSTALLING THE STAINLESS STEEL AHNDLE
This appliance includes a stainless steel handle that is not required to
operate the unit. To install the handle, follow the instructions below:
1. Use a screwdriver to remove the screws on the side of door
where the handle is to be installed.
2. Align the handle with the screws removed in step # 1. Tighten the
screws using a Phillips head screwdriver until the handle is both
flush and secured tightly against the door side. (DO NOT over-
tighten as this will cause damage to the stainless steel door
surface.)
It is recommended that you install the appliance in a place where the ambient temperature is between 72º
and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The operating temperature range may not be
reached.
CONTROL PANEL
ON/OFF Power
To turn the appliance off, press and hold the
off. To turn the appliance on, press and hold the
lights up.
NOTE: Pressing this POWER key once can switch off the audible alarm when the alarm is on.
OPERATING YOUR APPLIANCE
Handle
key for 5 seconds until the temperature display goes
key for 1 second until the temperature display
8
Screw
Door
Advertisement
Table of Contents
