Wireless Setup Troubleshooting - THOMSON Speedtouch 580 Installation And Setup Manual

Chapter 4
Internet Connection Troubleshooting
Restoring Windows
Zero Configuration
Uninstalling the
SpeedTouch™ Wireless
Client Manager
40

4.5 Wireless Setup Troubleshooting

When installing a SpeedTouch™110g/120g/121g, the SpeedTouch™ Client Manager
will be installed. The SpeedTouch™ Client Manager is an alternative to the
Windows Zero Configuration (WZC) in Windows XP. In many cases the
SpeedTouch™ Client Manager will disable the WZC.
You need administrative privileges on your computer to restore the WZC
service.
For information about starting the WZC service, visit the Microsoft knowledge base
on http://support.microsoft.com.
Every time you reconnect to a WLAN the SpeedTouch™ Wireless Client Manager
will start itself up again though, forcing the WZC to go down.
Therefore, you might want to uninstall the SpeedTouch™ Wireless Client Manager.
Proceed as follows:
1
In the Windows XP task bar, click the Start button
2
Select (All) Programs > SpeedTouch 110g/120g/121g Wireless Monitor >
Uninstall SpeedTouch 110g/120g/121g Wireless Monitor.
3
The Uninstall wizard will start running. Click OK to confirm you want to
uninstall.
4
The Install Shield Wizard will appear and will notify the SpeedTouch ST110g/
120g/121g Monitor is successfully uninstalled. Click Finish to close the wizard.
5
After uninstalling the SpeedTouch™ Wireless Client Manager, you can restore
the WZC.
E-DOC-CTC-20050429-0061 v2.0