THOMSON Speedtouch 580 Installation And Setup Manual page 30

Chapter 2
Basic Installation
Installing Mac USB
24
4
The Windows Found New Hardware Wizard appears. This wizard will guide
you through the installation procedure of the USB drivers.
Click Next to continue.
The Windows Found New Hardware Wizard may ask your
authorisation to connect to Windows Update to search for software. If
this is the case, select No, not this time and click Next.
5
Make sure that the SpeedTouch™ Setup CD is inserted, then select Instal the
software automatically (Recommended), and click Next.
6
The USB driver is being installed. After a while a completing dialogue will
appear. Click Finish, to close the wizard.
Continue with "Configuring the SpeedTouch™ (and your computer)" on page
You will find the required USB driver software on the Setup CD. The installation is
drivers
plug and play, meaning that installation will require almost no effort.
Proceed as follows:
1
Insert the blue USB cable provided into the SpeedTouch™ USB port marked
with the USB logo.
An USB logo looks like this:
2
The other end of the USB cable fits in (one of) the USB port(s) of your
computer. In most cases your computer's USB port is marked with the same
USB symbol.
You can also connect your computer to the SpeedTouch™ via a USB
hub, provided that the hub is autonomously powered.
3
Mac OS X will automatically recognise the detection of a new port.
4
Make sure the SpeedTouch™ Setup CD is inserted, then click OK.
5
In the Network window, click Apply Now.
Continue with "Configuring the SpeedTouch™ (and your computer)" on page
14.
14.
E-DOC-CTC-20050429-0061 v2.0