Battery - BMW S 1000XR 2018 Rider's Manual

ATTENTION
Current too high when jump-
starting the motorcycle
Cable fire or damage to the mo-
torcycle electronics
Do not jump-start the motor-
cycle using the power socket,
only via the battery terminal.
ATTENTION
Contact between crocodile
clips of jump leads and mo-
torcycle
Danger of short circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
higher than 12 V
Damage to the motorcycle's
electronics
The battery of the donor vehi-
cle must not exceed a voltage
of 12 V.
Do not disconnect battery from
onboard electrical system for
jump-starting procedure.
Removing seat ( 62).
Allow engine on support mo-
torcycle to run while jump-
starting.
Begin by clamping one end of
the red jumper cable to the
positive terminal of the dis-
charged battery and clamping
the other end to the positive
terminal of the donor battery.
Then clamp one end of the
black jumper cable to the
donor battery's negative
terminal while connecting
the other end to discharged
battery's negative terminal.
Start engine of vehicle with dis-
charged battery in usual way;
if engine does not start, wait
a few minutes before repeat-
ing attempt in order to protect
starter motor and donor bat-
tery.
Allow both engines to idle for a
few minutes before disconnect-
ing jumper cables.
Disconnect jumper cable from
negative terminals first, then
disconnect second cable from
positive terminals.
Install seat ( 62).

Battery

Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential for
recognition of warranty claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry.
Do not open the battery.
Do not top up with water.
9
153
z