Changing The Custom Panel - KitchenAid KCCC151JBL0 Use & Care Manual

Hide thumbs Also See for KCCC151JBL0:

Use & care manual (16 pages)

Table Of Contents

Table of Contents

If the compactor is to be midway between "1" and "3,"

place the retaining bracket mounting screws through "2."

A. Countertop

B. Retaining bracket (provided in conversion kit)

7. Slowly lift the front slightly and roll compactor into the kitchen

cabinet opening.

8. Using 2 - #8 - 18 x ¹ ₂" mounting screws (provided in

conversion kit), fasten the retaining brackets (provided in

conversion kit) to the countertop with the mounting screws.

Countertop mounting

A. Countertop

B. Retaining bracket (provided in conversion kit)

C. Mounting screw (provided in conversion kit)

NOTE: If retaining brackets cannot be attached to the

underside of countertop, attach mounting clips (provided in

conversion kit) to retaining brackets. Fasten compactor to

kitchen cabinet face with mounting screws through the

mounting clips.

Cabinet-face mounting

A. Mounting clip (provided in conversion kit)

B. Kitchen cabinet

C. Retaining bracket (provided in conversion kit)

D. Mounting screw (provided in conversion kit)

9. Grasp sides of compactor drawer and place bottom of

drawer into tracks. Lift at the handle so drawer will go over

drawer stops. Close drawer. Check to see whether drawer

opens freely. If the toe plate rubs against floor, see "Adjusting

the Toe Plate" for further instructions.

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate clearance

may be changed as follows:

1. Mark on each side of the toe plate the amount of toe plate

that rubs the floor covering.

2. Remove the drawer from the unit. See Step 3 in the

"Unpacking" section.

3. Use a ruler and a pencil or chalk to draw a line between the

marks on each side of toe plate.

4. Use scissors or utility knife to cut toe plate along line.

5. Replace drawer. If toe plate still rubs floor covering, repeat

steps 1-4.