Download Print this page

Adjusting The Toe Plate; Changing The Decorative Panel - KitchenAid KCCC151 Manual

Kitchenaid operation/performance compactors kucc151, kccc151
Hide thumbs

Advertisement

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate
clearance may be changed as follows:
1. Mark on each side of the toe plate the amount of toe
plate that rubs the floor covering.
2. Remove the drawer from the unit. (See step 3 in the
"Unpacking Your Compactor" section.)
3. Use a ruler and a pencil or chalk to draw a line
between the marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering,
repeat steps 1-4.
Changing the
Decorative Panel
Custom-made panel dimensions
14
(37.2 cm)
Flat panel: A
7
" (5.6 mm) thick panel is required. This is
3 2
the same thickness as a standard
23
13
"
1 6
(60.5 cm)
"
5
8
1
" plywood or paneling.
4
7
"
3 2
(5.6 mm)
raised
panel or
decorative
trim
outer section
of panel
5
"
1 6
(8 mm)
both sides
Raised panel: The outer section of panel must be
(5.6 mm) thick to fit into trim. Raised panel dimensions as
shown above.
Trim for decorative panel
Order trim for installation of a custom-made panel through
your KitchenAid dealer or by calling the KitchenAid
Consumer Assistance Center at 1-800-422-1230. In
Canada, call 1-800-807-6777.
Trim for custom-made panels available are:
Part No. 9871381 (Brushed stainless steel)
Part No. 9871382 (White)
Part No. 9871383 (Black)
Part No. 9871384 (Almond)
Part No. 9871600 (Biscuit)
14
"
5
8
(37.2 cm)
1
1
"
4
(32 mm)
23
13
"
1 6
(60.5 cm)
5
"
1 6
(8 mm)
7
"
3 2
9

Hide quick links:

Advertisement

loading

  Also See for KitchenAid KCCC151

  Related Content for KitchenAid KCCC151

This manual is also suitable for:

Kucc151