Table of Contents
Advertisement
Getting started
Setting up the handset for use
The display is protected by a plastic film.
Inserting the batteries
Only use rechargeable batteries, as this could otherwise result in significant health
risks and personal injury. For example, the outer casing of the batteries could be
destroyed or the batteries could explode. The device could also malfunction or be
damaged as a result of using batteries that are not of the recommended type.
¤
Insert the batteries (for
correct +/- direction, see
diagram).
Charging the batteries
¤
Charge the batteries fully prior to first use in the
charging cradle or using a standard USB mains
adapter.
The batteries are fully charged when the power icon
disappears from the display.
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Attaching the belt clip
The handset has notches on each side for attaching the belt clip.
•
Attaching the belt clip:
handset so that the tabs on the belt clip click into place in the
notches.
•
Removing the belt clip:
with your right thumb.
between the clip and the casing.
remove.
8
Please remove the protective film!
¤
Fit the battery cover from
the top.
¤
Press the cover until it
clicks into place.
Press the belt clip onto the back of the
Press the centre of the belt clip firmly
Push the nail of your left thumb up
Slide the clip upwards to
Availability and operation of the functions
may differ on your telephone.
To re-open the battery cover:
¤
Insert a fingernail behind
the notch at the top of the
cover and slide it
downwards.
7 h
Advertisement
Table of Contents
