OLIMEX A20-OLINUXINO-LIME2-EMMC User Manual page 25

Open-source single-board android/linux mini-computer

Hide thumbs Also See for A20-OLINUXINO-LIME2-EMMC:

Table of Contents

A20-OLinuXino-MICRO user's manual

5. Connect USB cable to the mini USB connector

6. You will be asked for drivers for the bootloader. Navigate to the folder where you extracted the

PhoenixSuit and install the drivers from the respective executables (or manually point the installer

to the drivers folder in the PhoenixSuit installation path).

7. PhoenixSuit will detect the board and would ask for the method of writing the image. Choose

method of writing the image and confirm your wish to write the image.

8. Wait till upgrade succeeds as shown below:

There are different flavors of the Android and Linux distributions depending on whether you want

to use 50Hz HDMI or 60Hz HDMI or VGA or 7'' display or 10'' display etc. You might need to

change the configuration files inside (depending on your desirable output medium). How to do it is

explained in chapter 2.6 Calibrating a display.

Those images, the software required and further instructions might be found at the wiki page:

https://www.olimex.com/wiki/A20-OLinuXino-MICRO.

Page 25 of 56

Table of Contents

A20-olinuxino-micro-4gb A20-olinuxino-micro