DUROMAX XP10000EH Manual page 22

GENERATOR ASSEMBLY AND MOUNTING
Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please
follow the instructions below. If you will not be using the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place
unit on blocks to ease assembly.
2. Secure the support leg to the cradle with cap screws (M8 x 16) and lock nuts (M8)
(see figure 22).
3. Secure the axle to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see figure
23).
4. Slide a wheel over the axle, then secure the wheel with a retaining pin.
(see figure 24、Figure 25、Figure 26).
5. Position the handles on the cradle and attach with cap screws (M8 X 16) and lock nuts
(M8) ( Figure 27、Figure 28).
5. Check that all fasteners are tight.
Figure 22
Figure 25
Figure 28
Figure 23
Figure 26
Page 22 of 29
Figure 24
Figure 27