Back Panel Connections - T+A R Series User Manual


GND

OUT

R2
LINK

Mains input
32
Connections
Earth (ground) clamp
Only for G 2000 R version without internal phono module.
Connect this terminal to the earthing point on your amplifier.
Do not use if internal phono module is installed.
Output sockets
If your G 2000 R version is not supplied with a factory-fitted PHONO pre-
amplifier module:
Connect these sockets to a PHONO input on your amplifier.

Please note: if the G 2000 R is not fitted with a phono module, this facility must
be present in your amplifier or receiver.
If your G 2000 R is supplied with a factory-fitted PHONO pre-amplifier
module:
Connect these sockets to a high-level (line) input on your amplifier.

Use one of the following inputs to connect the G 2000 R, depending on your
model of amplifier:
Input Device
IN 4 PA 2000 R, PA 2500 R
Control input for connecting to  units with the R2
 PA 2000 R amplifier).
The mains lead should be connected to this socket.
control system (e. g.
LINK