Back Panel Connections - T+A G10 User Manual

 
 
GND
Earth (ground) clamp
Only for G10 version without internal phono module.
Connect this terminal to the earthing point on your
amplifier.
Do not use if internal phono module is installed
   
OUT
Output sockets
If your G10 version is not supplied with a factory-
fitted PHONO pre-amplifier module:
Connect these sockets to a PHONO input on your
amplifier.
If your G10 is supplied with a factory-fitted PHONO
pre-amplifier module:
Connect these sockets to a high-level (line) input on your
amplifier.
Care of the unit:
Disconnect the mains plug from the wall socket before
cleaning the turntable.
To clean the machine simply wipe the surfaces with a
soft, damp cloth or sponge. Do not rub the surfaces with
Please just use clean water to moisten
a dry cloth.
the cloth, or water with a small addition of a mild
cleaning agent such as a neutral cleaner, soft soap
or similar.
Never use any organic solvent which
might contain materials such as paint thinners,
alcohol or lighter fuel.
Before using the unit again be sure to check that there
are no short-circuits at the connections, and that all con-
nectors are correctly fitted and firmly inserted.
Connections
 
 
R
Link
Control input for connecting to  units with the R
control system (e. g.  V10 amplifier).
 
 
Mains input
The mains lead should be connected to this socket.
24
LINK