Zero Return Function; Video Index Search System - Sharp DV-RW250H Operation Manual

ZERO RETURN function / Video index search system

ZERO RETURN function

This function makes tape
rewinding (or forwarding) stop at
the counter "00:00:00" position
automatically.
NOTES for Counter Display:
• If you rewind the tape beyond
"00:00:00", a minus sign ("–") will
be displayed in front of the time.
• When you load a tape, the counter
will reset to "00:00:00".
• The counter does not function on
nonrecorded (blank) sections of
the tape. When you rewind, fast
forward or play tapes through
blank sections, the counter stops.
NOTES for Video index search
system:
• When you record an INDEX mark
at the very beginning of the tape,
the mark may not be found.
• During INDEX search, the tape
may stop and begin to play at a
slightly different location.
• INDEX may not function properly
with old or worn out video tapes.
• INDEX marks may not be found if
it is extremely close to the point
where the search began.
• In recording, if you stop recording
temporarily, the INDEX mark is not
recorded on the tape.
1
Press DISPLAY.
The counter display shows the tape run-
ning time during playback or recording.
2
Press COUNTER RESET at the desired
tape position. The counter display will be
reset to the "00:00:00" position (e.g. the
beginning of recording).
3
Press STOP when playback or recording is finished.
Press ZERO RETURN.
The tape will be rewound or fast forwarded and automatically stop
at the "00:00:00" position.
Switching the display between clock and counter
Press CLOCK/COUNTER. The clock
and tape counter alternate with each
other in the display.

Video index search system

This function enables you to locate the beginning of any record-
ing made on the VCR.
Recording an INDEX MARK
The Index search function automatically records
an INDEX mark on the tape whenever a record-
ing is initiated.
Index search
Press INDEX or
mode.
For Succeeding programs: Press INDEX
For Preceding programs: Press INDEX
(Additional press increases the INDEX NO.
up to 9.)
When the INDEX or
unit starts searching the INDEX NO. selected
and finds the portion, then playback starts
automatically.
To stop the Index Search, press STOP.
during stop or play
.
.
is pressed, the
8 : 47 MON
00 : 04 : 38 SP
8 : 47 MON
00 : 00 : 00 SP
CH 1
INDEX
+3
or is displayed
INDEX NO. (up to 9)
47