Automatic Tv Tuning And Clock Setting - Sharp DV-RW250H Operation Manual

Automatic TV tuning and clock setting

Plug in your unit into the mains supply and it will start to
automatically tune itself in and set the correct date and
time. After setting itself up, you must set the TV to the
video channel.
ONLY WHEN YOU PLUG IN THIS UNIT FOR THE
FIRST TIME, THE AUTOMATIC SETUP WILL BE
AVAILABLE.
OPERATE
Preparation:
• Make sure that your unit is connected properly to the
TV.
• If a satellite receiver is connected with the coaxial
lead, make sure it's switched ON and set to SKY ONE.
• Turn on the TV and select the channel you wish to
allocate for video use.
1
Plug in your unit's plug into
the mains supply. "Auto"
will start to flash in the unit
display. And also "AUTO
TUNING" will be displayed
on the TV screen. Your
unit will automatically tune
itself in and set the correct
time and date (This may
take approx. 4 minutes).
2
Press and hold the OPER-
ATE button on the front of
your unit in the Standby
mode until RF output
channel "36" will appear in
the unit display.
3
If you have used a 21PIN
scart lead you now, sim-
ply select the AV channel
on your TV and go to step
5. Tune the TV in the
same way as tuning in a
TV broadcast station until the word "TEST" flashes
on the TV screen. Refer to the TV operating in-
structions for tuning. Now the output from the unit
is tuned to this channel. Whenever you want to play
back a tape, select this channel.
18
4
If there is interference from an adjacent broadcast
channel in the picture (wavy lines, picture roll, etc.),
press the CH
any other RF channel between 23 and 69, retun-
ing your TV until the word "TEST" flashes on the
TV screen. If you connected a satellite receiver as
explained on page 16, you must switch off the
VCR's transmitter. Press the unit's CH
buttons repeatedly until
OFF appears in the
display window (OFF will
appear after 69 or before
23).
CH /
5
Press the OPERATE button to turn OFF the unit.
Now the TV is tuned to your unit.
NOTES:
• The unit automatically corrects the clock setting every
hour and automatically adjusts the clock setting for
Daylight Saving Time.
• Your unit will tune the TV stations as follows.
• If you want to change the RF output channel or switch
to "OFF", press and hold the OPERATE button on the
front of your unit in the Standby mode until the current
AUTO TUNING
RF output channel appears. Press the CH
buttons on your unit to select the RF channel you
desire.
CH
TEST
/ buttons on your unit to select
CH 1 BBC 1 CH 5 Channel 5
CH 2 BBC 2 CH 6 Satellite
CH 3 ITV CH 7 etc.
CH 4 Channel 4
/
/