Introduction
Congratulations on your purchase of Extech's MN35 Manual Ranging Multimeter. This meter
measures AC/DC Voltage, DC Current, Resistance, Temperature, Battery Test, Diode Test and
Continuity. This meter is shipped fully tested and calibrated and, with proper use, will provide
years of reliable service. Please visit our website (www.extech.com) to check for the latest version
of this User Guide, Product Updates, and Customer Support.
Safety
International Safety Symbols
This symbol, adjacent to another symbol or terminal, indicates the user must refer to the
manual for further information.
This symbol, adjacent to a terminal, indicates that, under normal use, hazardous voltages
may be present
Double insulation
Safety Precautions
1. Improper use of this meter can cause damage, shock, injury or death. Read and understand this
user manual before operating the meter.
2. Make sure any covers or battery doors are properly closed and ured.
3. Always remove the test leads before replacing the battery or fuses.
4. Inspect the condition of the test leads and the meter itself for any damage before operating the
meter. Repair any damage before use.
5. Do not exceed the maximum rated input limits.
6. Use great care when making measurements if the voltages are greater than 25VAC rms or
35VDC. These voltages are considered a shock hazard.
7. Always discharge capacitors and remove power from the device under test before performing
Diode, Resistance or Continuity tests.
8. Remove the battery from the meter if the meter is to be stored for long periods.
9. To avoid electric shock, do not measure AC current of any kind
Function
VDC, VAC
Resistance, Diode, Continuity
mA DC
10A DC
800.561.8187
Input Limits
Maximum Input
600V DC/AC
500V DC/AC
250mA DC
10A DC (15sec. max every 15 min.)
2
www.
.com
MN35-EU-EN V2.3 4/13
information@itm.com