Table of Contents
Advertisement
STEP 3 : Plug into your telephone socket
1. Plug into your telephone socket.
¨
The plug only fits in one way round.
¨
If the plug doesn't fit your telephone
socket, contact BT or your telephone
network provider.
2. Extend the base aerial vertically. Your
CC10 is now ready for use.
Separate handset battery charger
A separate handset battery charger may be supplied with your telephone,
or alternatively, is available as an option. This lets you keep the handset
charged away from the base unit. The charger is designed for indoor use
only.
The charger is fitted with a permanently wired power adaptor. The power
adaptor should be plugged into a mains power socket and the supply switched
on.
Note: This separate charger is to be used as a remote charging function only
and cannot be used to set up the handset communication link. This can only
be done by placing the handset onto the main base unit. (See step 2).
When the handset is placed in the charger, a red light will come on after 5 to
10 seconds to show that charging is taking place. The light will remain on even
when the battery is fully charged.
IMPORTANT: Should the power adaptor or lead become damaged, the
entire charger must be replaced. Do not attempt to replace the lead or fit any
type of replacement adaptor/plug.
SETTING UP & USE
SETTING UP & USE
SETTING UP & USE
SETTING UP & USE
SETTING UP & USE
4
To make a call
¨ Extend the handset aerial, press Talk/End, await dial tone and dial.
The In Use lights on the base unit and handset come on. (To show
communication link is made.)
To answer a call
¨ Lift handset, extend the aerial and speak. (If the handset was off the base
unit or charger, press any button before speaking).
To end a call
¨ Press Talk/End. Or put the handset on the base unit or charger.
¨ Make sure the In Use light goes out.
Caution: be careful not to bend the aerial. Push it back in very gently.
Advertisement
Table of Contents
