Connecting Audio Components; Connecting Video Components - Gateway LN-520 Operating Instructions Manual

Digital a/v receiver
Table of Contents

Advertisement

SYSTEM CONNECTIONS
2. CONNECTING DIGITAL INs and OUT
• The COAXIAL or the OPTICAL DIGITAL OUTs of the components that are connected to AUX and VIDEO 1~3 of this unit can
be connected to these DIGITAL INs.
• If a digital recorder or other component with OPTICAL DIGI-
TAL IN/OUT jacks is connected to the corresponding jacks of
this unit, you can playback and/or record the high quality
sound of CD's, etc. without analog conversion or degradation.
• A digital input should be connected to the components such
as a CD player, LD player, DVD player, etc. capable ofout-
putting DTS Digital Surround, Dolby Digital or PCM format
digital signals, etc.
• For details, refer to the operating instructions of the compo-
nent connected.
• When making the COAXIAL DIGITAL connection, be sure to
use a 75 COAXIAL cord, not a conventional AUDIO cord.
• All of the commercially available optical fiber cords cannot be
used for the equipment. If there is an optical fiber cord which
cannot be connected to your equipment, consult your dealer
or nearest service organization.

3. CONNECTING AUDIO COMPONENTS

• The AUX jacks may be connected to an additional audio component such as a CD player, a tape deck, etc.
• The TAPE IN/OUT jacks can be connected to PLAY(OUT) / REC(IN) jacks of MD recorder.
AUX
CD player, tape deck, etc.
L
AUDIO
OUT
R

4. CONNECTING VIDEO COMPONENTS

• This unit incorporates S-VIDEO and composite (normal) VIDEO jacks.
For your reference, the excellence in picture quality is as follows: "S-VIDEO" > composite(normal) "VIDEO"
• A signal input into the composite(normal) VIDEO IN jack will be output in the composite(normal) VIDEO OUT jacks and a
signal input into the S-VIDEO IN jack will be output in the S-VIDEO OUT jacks and the composite (normal) MONITOR 1/2
VIDEO OUT jacks.
• The next picture is different from your real back pannel; just for helping your understnading.
When you connecting the components on the real back pannel, refer to the sticker on top cover.
5
OPT 1
OUT
IN
IN
VIDEO 1
VIDEO 2
VIDEO 3
www.gateway.com
DIGITAL
OUT
OPT 2
COAX
OPT
DIGITAL IN
CENTER
SUB WOOFER
TAPE
FRONT
SURROUND SURR.BACK
7CH DIRECT INPUT
Component such as
an MD recorder, CD recorder
with OPTICAL DIGITAL IN
Component with
COAXIAL DIGITAL OUT
Component with
OPTICAL DIGITAL OUT
Component with
OPTICAL DIGITAL OUT
L
AUDIO
OUT
R
L
AUDIO
IN
R
Tape deck, MD recorder, etc.

Advertisement

Table of Contents
loading

Table of Contents