APPENDIX
INITIALIZING THE SYSTEM
• When the display is not normal or when the operation of the unit does not shows the reasonable result, the
initialization of this unit is required by the following procedure.
1
In standby mode, press SETUP and
DECODING buttons at the same time.
SETUP
MEMORY
SETTING UP THE SYSTEM ON FRONT PANEL
• You can adjust the system settings in succession according to your system using the buttons on the front panel.
• This section explains how to adjust the settings using the buttons on the front panel.
• Refer to the corresponding pages indicated in ( ) for details about each mode and use of remote control.
Press the SETUP button for more than 2 seconds, then it enters the setup mode.
1
While displaying the setup mode, each time the SETUP button is pressed, the setup mode changes as
follows:
While displaying the selected setup mode, each time the DECODING button is pressed, the setting mode changes
2
as follows:
While displaying the selected setting mode, each time the ADJUST UP(▲) or DOWN(▼) button is pressed, the
3
mode is adjusted to the desired setting.
Notes:
• Only when selecting preset channel levels, press ADJUST UP(▲) or DOWN(▼) button to change the setting
mode and DECODING button to confirm your decision(refer to page 25).
• If the display of the corresponding mode disappears, start from the step 1 again.
• To help your understanding, each setting operation is explained with using its default setting.
DECODING
TUNE MODE
www.gateway.com
After seeing the flickering standby
2
indicator, take your hand(s) off from
buttons.
• If this unit has been reset, all the button settings
are reset to the default values (the values set upon
shipment from the factory).
40