Table of Contents
Advertisement
OPERATIONS
Adjusting each channel level with test tone
• You can adjust the level of test tone for each channel so that they are all heard at the same level.
Note : When the 7 CH DIRECT is selected as an input source or the headphones are plugged, the test tone function does
not work.
Enter the test tone mode.
1
At each channel, adjust the level so that
2
they are all heard at the same level.
• You can select the desired channel and adjust its level
with repeating the steps 1 and 2 in "Adjusting each
channel level" procedure.
Adjusting each channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to
suit your tastes.
• You can also adjust the channel levels with using the buttons on the front panel.
(For details, refer to "SETTING UP THE SYSTEM ON FRONT PANEL" on page 40.)
Select the desired channel.
1
• When it is in the stereo or Dolby Virtual mode or the speaker setting is "N", center, surround
L/R, surround back or subwoofer channel will not be selected.
• When the headphones are plugged, only the front L/R channel can be selected.
T.TONE
CH/LEVEL
∧,∨
CH.SEL
www.gateway.com
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL
C
FR
Front Left
Center
Front Right
SW
SL
Subwoofer
Surround
Left
• When the speaker setting is "N", the test tone of the
corresponding channel is not available.
Cancel the test tone function.
3
• Each time this button is pressed, the
corresponding channel is selected and
displayed for several seconds as follows:
FL
C
Front Left
Center
Front Right
SW
SL
Subwoofer
Surround
Left
SR
Surround
Right
SB
Surround
Back
T.TONE
FR
SR
Surround
Right
SB
Surround
Back
24
Advertisement
Table of Contents
