Table of Contents
Advertisement
UNIVERSAL REMOTE CONTROLS
OPERATING COMPONENTS WITH REMOTE CONTROL
1
Enter the setup code for each component
other than this receiver you wish to
control. For details, refer to "Entering a
setup code" on page 12.
2
Turn on the component you want to
operate.
3
Press the DEVICE button on the remote
control corresponding to the component
you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
LOADING BATTERIES
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
1
Remove the cover.
11
REMOTE CONTROL OPERATION RANGE
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
2
Load two batteries matching the polarity.
("AAA" size)
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
www.gateway.com
M1
M2
M3
T/V
+10
1
2
3
4
5
6
7
8
9
0
2×1.5V
Advertisement
Table of Contents
