Table of Contents
Advertisement
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time.
Please press the signal [Source] button on the remote control to search for the
available input signals. Then select the desired signal.
1.
Press [Source] to display the source selection column.
2.
Keep pressing the / until you arrive at the desired signal, then press [Enter].
Once the signal source is detected, the green dot near the available signal source
icon will light up.
For display resolutions of this projector, please refer to
To achieve the best image display effects, you should select and use an input signal that
outputs at this resolution. Any other resolutions will be scaled by the projector depending upon
the aspect ratio setting, which may cause some image distortion or loss of picture clarity. See
"Select the aspect ratio"
for details.
26
"Projector
specifications".
Advertisement
Table of Contents
