Operating Modes - Lexicon M300L Owner's Manual

300L Owner's Manual

Operating Modes

2-4
The 300L is always in one of the following four operating modes:
Setup (preset or register) Select Mode
Program Preview Mode
Register Preview Mode
Control Mode
The 300L always powers up in its last operating state.
Each mode, and the paths for entering and exiting it are described below.
Setup Select Mode
Press SETUP.
This mode allows you to:
• View the machine currently being addressed by the LARC
• Display the program or preset currently running in the machine
• View and/or alter parameters
Program Preview Mode
Press PROG.
Press BANK to view program banks.
Press PROG to view programs in the bank.
This mode allows you to:
• Select factory programs
Register Preview Mode
Press REG.
Press BANK to view register banks
Press REG to view programs in the bank
This mode allows you to:
• Select, store, and recall programs from registers
Control Mode
Press CTRL. To exit, press CTRL again.
This mode allows you to:
• View system status
• Alter input and set digital operation
• Address the register transporter
• Transmit MIDI Program Change messages
• Enable MIDI SysEx Automation
* Transmit MIDI Bulk Dumps
• Enable time code
• Edit time code Event List
Lexicon