Single Setups - Lexicon M300L Owner's Manual

OUT Output Types and Patch Points
Typically the 300L operates with both analog and digital outputs active. However
in the Dual-Mono and Cascade there are other options. When ANALOG inputs
are selected, the DIGITAL inputs and outputs are available as patch points,
either pre or post processing. When the DIGITAL inputs are selected, the
ANALOG inputs and outputs are available. In Cascade operation, the patch
point resource becomes available mid-DSP as well. The OUT slider gives you
access to the patch points. Similar to a "half - normalled" patch bay on a mixing
console, the outputs are always active. Selecting a patch point with this slider
effectively breaks the normal and requires a return input in order for the unit to
continue passing audio.
OFMT Selecting the Digital Output Format
This slider allows you to select AES Professional or S/PDIF (Sony/Phillips Digital
InterFace) Consumer asdigital output formats.
Single Setups (1-100) configure both DSP engines with microcode which
enables them to function as a unified engine. Both analog and digital inputs can
be utilized simultaneously. Each type of input (A or D) has a source Level and
Balance control. The Level control varies the input level to the DSP engine for
each type of input; Analog or Digital. The Balance controls determine what ratio
of Left/Right balance feeds the DSP engine. The Setup signal path is shown
below.
Analog
L
Analog
Level
R
Digital
L
Digital
Level
R
(Analog and digital input levels and balances are located on Page 2 of the Setup
mode. From the Setup display, press PAGE to view Page 2.)
ANA: LVL
Σ
Analog
Balance
Digital
Balance
BAL DIG:
Dry
EFFECT
EDIT
Σ
Dry
LVL BAL
System Operation

Single Setups

Analog and
Digital Out
L
Overall
Mix
R
3-5