Power - Gateway Solo 5300 User Manual

To create a startup password:
1
Restart your notebook. As soon as you see a startup screen, press F2.
The BIOS Setup utility opens.
2
Open the
E
NTER
3
Highlight
4
Highlight
instructions. You must set the supervisor password in order to set
the user (startup) password.
5
Highlight
instructions. This is the password you need to enter at startup.
6
Exit the BIOS Setup utility by opening the
Exit Saving Changes
prompted to enter the user password you set in Step 5.

Power

To get the best performance from your notebook, avoid using the battery
whenever possible, monitor the battery charge, and use the most efficient
power management settings.
For information on conserving battery power, see "Conserving battery
power" on page 112.
For information on using alternate power sources, see "Using alternate
power sources" on page 112.
For information on monitoring the battery charge, see "Monitoring the
battery charge" on page 106.
menu, then highlight
Security
.
, then press E
Enabled
Set Supervisor Password
Set User Password
. When you start your computer, you are
www.gateway.com
Password on boot
.
NTER
, then press E
, then press E
NTER
menu, then selecting
Exit
and press
and follow the
NTER
and follow the
125