[Digital Link Status]; [Wired Lan] - Panasonic PT-VW535N Operating Instructions Manual

[AUTONEGOTIATION]
[100BaseTX-Full]
[100BaseTX-Half]
5) Press as to select [STORE].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The projector does not support 10BaseT Full/Half.
When the projector is connected to a twisted-pair-cable transmitter
1) Press as to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
f The [DIGITAL LINK SETUP] screen is displayed.
3) Press as to select [DUPLEX(DIGITAL LINK)].
4) Press qw to switch the communication method.
f The items will switch each time you press the button.
[100BaseTX-Full]
[100BaseTX-Half]
[AUTONEGOTIATION]
5) Press as to select [STORE].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

[DIGITAL LINK STATUS]

Display DIGITAL LINK connection environment.
1) Press as to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
f The [DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS]
[HDCP STATUS]
[SIGNAL QUALITY]

[WIRED LAN]

You can make detailed wired LAN settings.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
Chapter 4 Settings - [NETWORK/USB] menu
The communication method is set automatically.
Full-duplex communication method is set.
Half-duplex communication method is set.
Full-duplex communication method is set.
Half-duplex communication method is set.
The communication method is set automatically.
Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.
Either [NO SIGNAL], [OFF], or [ON] is displayed.
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color
changes to green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable
transmitter.
f MAX/MIN: Maximum/minimum value of the amount of error.
f Green (-12 dB or lower) → Normal signal quality level.
f Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced
on the screen.
f Red (-7 dB or higher) → Abnormal level where synchronization may be interrupted or a
signal may not be received.
ENGLISH - 89